hola, acabo de instalar Zorin en un equipo bastante antiguo (macbook air 2008) tengo un problema al conectarme a cualquier red aparece un signo "?" no me arroja error alguno, sólo no me deja navegar de manera inalámbrica ( ahora estoy conectado vía ethernet, les proporciono mis datos
The older Macbooks use Broadcom, which considers its drivers proprietary.
Can you connect using your phone tethered as a hotspot or other means?
If so, run
sudo apt update
sudo apt install bcmwl-kernel-source
OR (Since it is a 2008):
sudo apt install firmware-b43-installer
1 Like
tuvo un error al instalar firmware b43 
no encontró actualizaciones perdientes con los anteriores comandos
Zorin may already show which drivers to install.
- First Connect to internet using your Ethernet
- Launch Software & Updates
- Navigate to Additional tab
- Check if any drivers are available
- If available, install them and reboot your system
1 Like
If wifi is connecting OK and just showing as ? then that maybe due to connection checking.
In Zorin>Settings>Privacy>
Toggle connection check on/off or off/on and the "?" will go away.
I get that ? all the time, its annoying, but does not affect wifi operation.
1 Like
Welcome to the Forum!
Which one of @Aravisian's Commands didn't work? Can You post a Picture of the Error? And could You post the Output of the Command sudo lshw -C network please?
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.