Hallo mede Zorin gebruikers,
Ik ben bezig mijn oude samsung telefoon de android software te updaten.
Heb via samsung site het programma SmartSwitch gedownload en geinstalleerd in Zorin 17.3.
het programma werkt wel maar het programma herkend de telefoon de telefoon niet.
Welke hardware instelling moet ik veranderen zodat de telefoon wel zichtbaar is in de SmartSwitch software ?
Heb je het programma als Flatpak geïnstalleerd? Dan moet je ook Flatseal installeren om het programma toegangsrechten te geven.
Have you installed the programme as a flat pack? Then you should also install Flatseal to grant the programme access rights.
Ik heb gelezen dat het programma niet wordt ondersteund in Linux. Je k unt echter wel andere programma's gebruiken om je telefoon te verbinden.
I have read that the program is not supported in Linux. However, you can use other programs to connect your phone.
De app heet Zorin connect.
The app is called Zorin connect.
This is correct. Samsung SmartSwitch is for use on Samsung Galaxy devices only.
Samsung SmartSwitch is not limited to just Samsung "Galaxy" devices, you can use with other Samsung android phones and tablets as well. But is a Windows program for PC.
Ik heb nu alles wat nodig geinstalleerd in Zorin en met Zorin Connect heb ik wel verbinding met de telefoon maar met Smart Switch krijg ik geen verbinding met het telefoon om mijn android te kunnen updaten.
Het gaat bij mij erom om alleen de android versie te updaten op mijn toestel (Samsung xcover 4) zodat ik hem weer langer kan gebruiken.
Hebben jullie nog ideen om toch de bv de android 10 op mijn toestel te krijgen, het lukt nu niet via het toestel.
Ah. I was going by Samsungs description:
About Samsung Smart Switch
Samsung Smart Switch seamlessly transfers contacts, photos, music, videos, messages, notes, calendars and more to virtually any Samsung Galaxy device.